/* This is the workfile to change pin allocations

	2017-12-16	QBridge11 for Atmega1284P
	2018-05-10	Adapt to real Q-Bus
	2018-06-04	Change some pins so with only small changes to the routing of signals
				the pin layout for the Atmega12848P is the same as for the RLV12 which
				was built for the PDP-11/Hack based on the QBridge11.

*/

Device   f1508isptqfp100;

/*************************** Control Bus *******************************************************/
PIN   45   =  TSYNC          ; /* Address Latch Enable Transmit                           QBUS */
PIN   52   =  RSYNC          ; /* Address Latch Enable Receive                            QBUS */
PIN   40   =  RINIT          ; /* Master reset                                            QBUS */
PIN   48   =  TDOUT          ; /* IO Bus write Tramsmit                                   QBUS */
PIN   55   =  RDOUT          ; /* IO Bus write Receive                                    QBUS */
PIN   41   =  RIAKI          ; /* Interrupt acknowledge daisy chain in                    QBUS */
PIN   42   =  TIRQ           ; /* Interrupt request                                       QBUS */
PIN   35   =  TIAKO          ; /* Interrupt acknowledge daisy chain out                   QBUS */

PIN   33   =  TDMR           ; /* DMA Request                                             QBUS */
PIN   37   =  RDMGI          ; /* DMA Grant In                                            QBUS */
PIN   32   =  TDMGO          ; /* DMA Grant Out                                           QBUS */
PIN   31   =  TSACK          ; /* Service Acknowledge                                     QBUS */

PIN   46   =  TDIN           ; /* IO Bus read Transmit                                    QBUS */
PIN   53   =  RDIN           ; /* IO Bus read Receive                                     QBUS */
PIN   44   =  TWTBT          ; /* Multiplexed Write/Byte                                  QBUS */
PIN   54   =  RWTBT          ; /* Multiplexed Write/Byte                                  QBUS */
PIN   36   =  RBS7           ; /* Bank Select 7 i.e. registers in IO page                 QBUS */
PIN   47   =  TRPLY          ; /* Reply Transmit                                          QBUS */
PIN   56   =  RRPLY          ; /* Reply Receive                                           QBUS */

/*************************** Address/Data Bus **************************************************/
PIN   21   =  DAL0           ; /* Data/Address Bus                                        QBUS */
PIN   23   =  DAL1           ; /*                                                         QBUS */
PIN   20   =  DAL2           ; /*                                                         QBUS */
PIN   19   =  DAL3           ; /*                                                         QBUS */
PIN   16   =  DAL4           ; /*                                                         QBUS */
PIN   14   =  DAL5           ; /*                                                         QBUS */
PIN   13   =  DAL6           ; /*                                                         QBUS */
PIN   12   =  DAL7           ; /*                                                         QBUS */
PIN   10   =  DAL8           ; /*                                                         QBUS */
PIN    9   =  DAL9           ; /*                                                         QBUS */
PIN    8   =  DAL10          ; /*                                                         QBUS */
PIN    7   =  DAL11          ; /*                                                         QBUS */
PIN    6   =  DAL12          ; /*                                                         QBUS */
PIN    5   =  DAL13          ; /*                                                         QBUS */
PIN    2   =  DAL14          ; /*                                                         QBUS */
PIN    1   =  DAL15          ; /*                                                         QBUS */
PIN   50   =  DAL16          ; /*                                                         QBUS */
PIN   49   =  DAL17          ; /*                                                         QBUS */
PIN   30   =  DAL18          ; /*                                                         QBUS */
PIN   29   =  DAL19          ; /*                                                         QBUS */
PIN   28   =  DAL20          ; /*                                                         QBUS */
PIN   27   =  DAL21          ; /*                                                         QBUS */


PIN   24   =  XMIT           ; /*                                                         CTRL */
PIN   22   =  REC            ; /*                                                         CTRL */

/*************************** AVR Interface *****************************************************/
PIN   87   =  CLK            ; /* Master Clock                                     Atmega1248P */

PIN   57   =  AD0            ; /* MCU <-> CPLD Data                                Atmega1248P */
PIN   58   =  AD1            ; /* "                                                Atmega1248P */
PIN   60   =  AD2            ; /* "                                                Atmega1248P */
PIN   61   =  AD3            ; /* "                                                Atmega1248P */
PIN   64   =  AD4            ; /* "                                                Atmega1248P */
PIN   65   =  AD5            ; /* "                                                Atmega1248P */
PIN   67   =  AD6            ; /* "                                                Atmega1248P */
PIN   68   =  AD7            ; /* "                                                Atmega1248P */

PIN  100   =  CRDY           ; /* Controller Ready                                 Atmega1248P */

PIN   81   =  INT0           ; /* DATO Interrupt                                   Atmega1248P */
PIN   84   =  INT1           ; /* DATI Interrupt                                   Atmega1248P */
PIN   80   =  RS0            ; /* Register Select 0                                Atmega1248P */
PIN   77   =  RS1            ; /* Register Select 1                                Atmega1248P */
PIN   98   =  RS2            ; /* Register Select 2                                Atmega1248P */
PIN   90   = !RD             ; /* Output Enable                                    Atmega1248P */
PIN   93   = !WR             ; /* Write Register                                   Atmega1248P */
PIN   96   =  IACK           ; /* "                                                Atmega1248P */
PIN   76   =  INT2           ; /* BINIT                                            Atmega1248P */

/*************************** DMA Singals *******************************************************/
PIN   99   =  SACK           ; /* Service Acknowledge                              Atmega1248P */
PIN   83   =  RPLY           ; /* BUS Reply                                        Atmega1248P */
PIN   92   =  DMG            ; /* DMA Grant Input                                  Atmega1248P */
PIN   97   =  DMR            ; /* DMA Request                                      Atmega1248P */
PIN   78   =  IRQST          ; /* Request Interrupt Cycle                          Atmega1284P */